Keywords: SST-1; Machine Control System; Central Control System;
مقالات ISI (ترجمه نشده)
مقالات زیر هنوز به فارسی ترجمه نشده اند.
در صورتی که به ترجمه آماده هر یک از مقالات زیر نیاز داشته باشید، می توانید سفارش دهید تا مترجمان با تجربه این مجموعه در اسرع وقت آن را برای شما ترجمه نمایند.
در صورتی که به ترجمه آماده هر یک از مقالات زیر نیاز داشته باشید، می توانید سفارش دهید تا مترجمان با تجربه این مجموعه در اسرع وقت آن را برای شما ترجمه نمایند.
Keywords: SST-1; MHD; Mirnov coils; Disruptions
MHD mode evolutions prior to minor and major disruptions in SST-1 plasma
Keywords: SST-1; MHD phenomena; Mirnov coils; Disruptions;
Design of a 500Â kW CW water load at 3.7Â GHz for the LHCD system of SST-1 tokamak
Keywords: LHCD; SST-1; Water load; High power; Absorber; Dummy load;
Design of the 3.7Â GHz, 500Â kW CW circulator for the LHCD system of the SST-1 tokamak
Keywords: Circulator; LHCD; SST-1; High power CW; Ferrite phase shifter; Coupler;
Overview of time synchronization system of steady state superconducting tokamak SST-1
Keywords: CCS; TS; DCS; GPS; TSS; SST-1;
Upgradation in SCADA and PLC of existing LN2 control system for SST-1
Keywords: Programmable logic controller; Supervisory control and data acquisition system; Cryogenics; SST-1;
Overview of data acquisition system for SST-1 diagnostics
Keywords: Data acquisition; PXI; SST-1; Tokamak; Diagnostics; TCP/IP;
Design of mass flow rate measurement system for SST-1 superconducting magnet system
Keywords: Data acquisition system; Helium mass flow measurement; SST-1; Venturi meter; Tokamak;
Implementation of time synchronized cryogenics control system network architecture for SST-1
Keywords: InSQL; SCADA; PLC; SST-1;
Instrumentation for status monitoring and protection of SST-1 superconducting magnets
Keywords: Superconducting magnet; Instrumentation; Sensor; SST-1; Tokamak;
New design aspects of cooling scheme for SST-1 plasma facing components
Keywords: SST-1; PFC; Heat flux; ANSYS analysis;
Quench characterization and thermo hydraulic analysis of SST-1 TF magnet busbar
Keywords: Busbar; Quench; Thermo hydraulic analyses; SST-1; Gandalf
Simulation study of induced EMFs and the suppression during SST-1 start-up
Keywords: SST-1; Induced EMF; Voltage suppression;
Cool Down Experiences with the SST-1 Helium Cryogenics System before and after Current Feeders System Modification
Keywords: current leads; superconducting magnets; cryo-stability; current charge; SST-1;
Design and implementation of data acquisition system for magnets of SST-1
Keywords: Data acquisition system; Superconducting magnets; VME; SST-1
Bridge joint fabrication and validation for SST-1 PF coil winding pack
Keywords: SST-1; Superconducting magnets; CICC; Terminations; Bridge type joint; Nano voltmeter
Thermo hydraulic and quench propagation characteristics of SST-1 TF coil
Keywords: SST-1; TF coil; Quench; Normal zone; Gandalf; Two phase and supercritical helium
Thermal Behavior of SST-1 Vacuum Vessel and Plasma Facing Components during Baking
Keywords: SST-1; nitrogen gas heating; PFC; thermal analysis; mass flow.;
Fabrication of new joints for SST-1 TF coil winding packs
Keywords: SST-1; TF coil; Winding pack; Low resistance joints; Fabrication process; Quality control
Performance validation tests on 80 K bubble type of shields for SST-1
Keywords: Heat loads; Temperature uniformity; Embossed shields; Leakages; SST-1
Design and development of signal conditioning electronics for SST-1 microwave interferometer system
Keywords: Microwave interferometer system; Aditya Tokamak; SST-1; DAQ; Plasma diagnostics; Signal conditioning electronics
Design and development of five-channel interference filter polychromator for SST-1 Thomson scattering system
Keywords: Filter polychromator; Thomson scattering; SST-1; Optical ray tracing; FPGA
Design of an ion extractor system for a prototype ion source experiment for SST-1 neutral beam injector
Keywords: 52.75.−d; 29.25.Lg.NiIon source; Extraction system; Neutral beam injector; SST-1
CORBA-based solution for remote participation in SST-1 tokamak control and operation
Keywords: Remote participation; Distributed control; MICO; CORBA; SST-1; MCS
Stability measurements with non-uniform current distribution in NbTi cable-in-conduit conductor for SST-1
Keywords: CICC; Non-uniform current distribution; Stability; SST-1
Inspection of brazed joints between cooling tube and heat sink of PFC for SST-1 tokamak by IR thermography technique
Keywords: Infrared thermography; Non-destructive technique; Brazing; Plasma facing components; Tokamak; SST-1; Thermal contact; Finite element analysis; X-ray imaging;