Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
10384809 | Wear | 2005 | 12 Pages |
Abstract
Finite element method (FEM) is a powerful tool to predict cutting process variables, which are difficult to obtain with experimental methods. In this paper, modelling techniques on continuous chip formation by using the commercial FEM code ABAQUS are discussed. A combination of three chip formation analysis steps including initial chip formation, chip growth and steady-state chip formation, is used to simulate the continuous chip formation process. Steady chip shape, cutting force, and heat flux at tool/chip and tool/work interface are obtained. Further, after introducing a heat transfer analysis, temperature distribution in the cutting insert at steady state is obtained. In this way, cutting process variables e.g. contact pressure (normal stress) at tool/chip and tool/work interface, relative sliding velocity and cutting temperature distribution at steady state are predicted. Many researches show that tool wear rate is dependent on these cutting process variables and their relationship is described by some wear rate models. Through implementing a Python-based tool wear estimate program, which launches chip formation analysis, reads predicted cutting process variables, calculates tool wear based on wear rate model and then updates tool geometry, tool wear progress in turning operation is estimated. In addition, the predicted crater wear and flank wear are verified with experimental results.
Related Topics
Physical Sciences and Engineering
Chemical Engineering
Colloid and Surface Chemistry
Authors
L.-J. Xie, J. Schmidt, C. Schmidt, F. Biesinger,