Effect of pre-strain on fracture toughness of ductile structural steels under static and dynamic loading

The ductile fracture process consists of void nucleation, growth and coalescence. The whole ductile process can be divided into two successive steps: (I) the initial state to void nucleation, followed by (II) void growth up to void coalescence. Based on this suggestion, resistance to ductile fracture could be divided into the resistance to stage I and stage II, and accordingly the whole fracture toughness could be regarded to be due to contributions from stages I and II. The fracture toughness contributed from the two steps is, respectively, denoted as void nucleation-contributed fracture toughness and void growth-contributed fracture toughness. The effect of plastic pre-strain on the fracture toughness of ductile structural steels under static and dynamic loading (4.9 m/s) within the ductile fracture range was evaluated by summing contributions due to void nucleation-contributed and void growth-contributed fracture toughness. The effect of strain rate on fracture toughness was also investigated by the same means. The results show that both plastic pre-strain and high-speed loading decrease the void nucleation-contributed fracture toughness while their effects on the void growth-contributed fracture toughness depend on the variations in strength and ductility. Moreover, fracture toughness of structural steels generally decreases with increasing strain rate.