Determination of selenium in biological samples by slurry sampling-electrothermal vaporization-in situ fusion-isotope dilution-microwave-induced nitrogen plasma mass spectrometry

Determination of selenium in certified reference biological materials by slurry sampling electrothermal vaporization (ETV)-isotope dilution (ID)-microwave-induced nitrogen plasma mass spectrometry (MIP-MS) was performed. Several parameters such as the heating conditions were studied in order to obtain optimal conditions. A special heating stage called the in situ fusion stage was applied just before the pyrolysis stage in the electrothermal vaporization process in order to fuse the biological sample and to achieve selenium isotope-equilibration between selenium in the sample and the 78Se spike solution. The slurry sample containing an appropriate amount of biological sample, 78Se spike solution, and sodium hydroxide as an alkaline flux was injected into the electrothermal vaporization unit. The slurry sample was in situ fused, pyrolyzed, and then vaporized. The ion counts at m/z=78 and 80, the spike and reference isotopes, respectively, could be measured accurately without interference caused by argon since nitrogen plasma was used. The analytical utility of the proposed slurry sampling-electrothermal vaporization-in situ fusion-microwave-induced nitrogen plasma mass spectrometry was evaluated by determining the selenium concentration in certified reference biological materials, and the analytical results obtained were in good agreement with the certified values. The limit of detection for selenium was 90 ng g−1. The relative standard deviation of the determination of selenium was 8-15% with a high sample throughput (less than 30 min per sample including a slurry preparation.)