Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
10558593 | Spectrochimica Acta Part B: Atomic Spectroscopy | 2005 | 7 Pages |
Abstract
An extended study of different sampling introduction approaches using inductively coupled plasma mass spectrometry (ICP-MS) is presented for the determination of boron in steel samples. The following systems for sample introduction were applied: direct sample solution nebulization by continuous nebulization (CN) using a cross-flow nebulizer and with flow injection (FI), applied to 0.1% (m/v) and 0.5% (m/v) sample solutions, respectively; FI after iron matrix extraction, using acetylacetone-chloroform, and isotopic dilution (ID) analysis as the calibration method; FI with on-line electrolytic matrix separation; and spark ablation (SA) and laser ablation (LA) as solid sampling techniques. External calibration with matrix-matching samples was used with CN, SA, and LA, and only acid solutions (without matrix matching) with FI methods. When FI was directly applied to a sample solution, the detection limit was of 0.15 μg gâ1, improving by a factor of 4 that was obtained from the CN measurements. Isotopic dilution analysis, after matrix removal by solvent extraction, made it possible to analyse boron with a detection limit of 0.02 μg gâ1 and, with the on-line electrolytic process, the detection limit was of 0.05 μg gâ1. The precision for concentrations above 10 times the detection limit was better than 2% for CN, as well as for FI methods. Spark and laser ablation sampling systems, avoiding digestion and sample preparation procedures, provided detection limits at the μg gâ1 levels, with RSD values better than 6% in both cases. Certified Reference Materials with B contents in the range 0.5-118 μg gâ1 were used for validation, finding a good agreement between certified and calculated values.
Related Topics
Physical Sciences and Engineering
Chemistry
Analytical Chemistry
Authors
A.G. Coedo, M.T. Dorado, I. Padilla,