Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
10668451 | Surface and Coatings Technology | 2011 | 5 Pages |
Abstract
CrAlN/BN nanocomposite coatings were deposited through reactive cosputtering, i.e., pulsed dc and rf sputtering, of CrAl and h-BN targets, respectively. X-ray diffraction (XRD) and selected area electron-diffraction (SAED) analysis indicated that the CrAlN/BN coating consists of very fine grains of B1 structured CrAlN phase. With an increasing BN volume fraction of over 8 vol.%, the nanocrystalline nature of the grains is revealed through a dispersion of fine grains in the CrAlN/BN coating. A cross-sectional observation using a transmission electron microscope (TEM) clarified that the coating demonstrating the highest level of hardness has a fiber-like structure consisting of grains that are ~ 20 nm in width and ~ 50 nm in length. X-ray photoelectron spectroscopy (XPS) analysis revealed that the coating consists mainly of CrAlN and h-BN phase. The indentation hardness (HIT) and effective Young's modulus (E*) of the coatings increased with the BN phase ratio, reaching a maximum value of ~ 46 and ~ 440 GPa at ~ 7 vol.% of BN phase; it then decreased moderately to ~ 40 and ~ 350 GPa at 18 vol.% of BN, respectively. Furthermore, CrAlN/BN coatings showed superior oxidation resistance compared with CrAlN coatings. After annealing at 800 °C in air for 1 h, the indentation hardness of CrAlN coatings decreased to 50% of the as-deposited hardness; in contrast, the hardness of CrAlN/BN nanocomposite coatings either stayed the same or increased, attaining a value of about 46 GPa. After annealing at 900 °C for 1 h, the hardness of all the coatings decreased to about 40%.
Related Topics
Physical Sciences and Engineering
Materials Science
Nanotechnology
Authors
M. Nose, T. Kawabata, T. Watanuki, S. Ueda, K. Fujii, K. Matsuda, S. Ikeno,