Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
10673553 | CIRP Annals - Manufacturing Technology | 2008 | 4 Pages |
Abstract
This paper presents a theoretical model for cutting force prediction in micro milling, taking into account the cutting edge radius size effect, the tool run out and the deviation of the chip flow angle from the inclination angle. A parameterization according to the uncut chip thickness to cutting edge radius ratio is used for the parameters involved in the force calculation. The model was verified by means of cutting force measurements in micro milling. The results show good agreement between predicted and measured forces. It is also demonstrated that the use of the Stabler's rule is a reasonable approximation and that micro end mill run out is effectively compensated by the deflections induced by the cutting forces.
Keywords
Related Topics
Physical Sciences and Engineering
Engineering
Industrial and Manufacturing Engineering
Authors
G. Bissacco, H.N. Hansen, J. Slunsky,