An investigation on electrochemical hydrogen storage performances of Mg-Y-Ni alloys prepared by mechanical milling

The nanocrystalline and amorphous Mg2Ni-type electrode alloys with a composition of Mg20–xYxNi10 (x=0, 1, 2, 3 and 4) were fabricated by mechanical milling. Effects of Y content on the structures and electrochemical hydrogen storage performances of the alloys were investigated in detail. The inspections of X-ray diffraction (XRD), transmission electron microscopy (TEM) and scanning electron microscopy (SEM) revealed that the substitution of Y for Mg brought on an obvious change in the phase composition of the alloys. The substitution of Y for Mg resulted in the formation of secondary YMgNi4 phases without altering the major phase Mg2Ni when Y content x≤1. But with the further increase of Y content, the major phase of the alloys changed into YMgNi4 phase. In addition, such substitution facilitated the glass forming of the Mg2Ni-type alloy. The discharge capacities of the as-milled alloys had the maximum values with Y content varying, but Y content with which the alloy yielded the biggest discharge capacity was changeable with milling time varying. The substitution of Y for Mg had an insignificant effect on the activation ability of the alloys, but it dramatically improved the cycle stability of the as-milled alloys. The effect of Y content on the electrochemical kinetics of the alloys was related to milling time. When milling time was 10 h, the high rate discharge ability (HRD), diffusion coefficient of hydrogen atom (D) and charge transfer rate all had the maximum value with Y content increasing, but they always decreased in the same condition when milling time increased to 70 h.

The discharge capacity of the alloy reaches the maximum value (352.8 mAh/g) when the ball milling time is 10 h and Y content is x = 3 (The addition of Y significantly promotes the cycle stability of the alloy electrodes)Figure optionsDownload full-size imageDownload as PowerPoint slide