| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 1295970 | Solid State Ionics | 2013 | 8 Pages |
•A low temperature fabrication method was applied to avoid formation secondary phases.•We investigated chemical compatibility and performance of infiltrated LSCM (or NiO)/LSGM.•The infiltrated LSCM particle size was 200 nm and uniformly spread over LSGM scaffold.•LSGM single cell was fabricated and tested with scaffold type anode infiltrating LSCM.•The maximum power density of single cell was 0.21 W/cm2 at 800 °C.
The phase stability and electrochemical properties of infiltrated anode catalysts on porous La0.8Sr0.2Ga0.8Mg0.2O3-δ (LSGM) scaffold are investigated for possible applications as anode materials for an intermediate temperature-operating solid oxide fuel cell (IT-SOFC).To avoid the formation of secondary phases between the anode and the LSGM electrolyte, an infiltration method is proposed on the porous LSGM scaffold. No secondary phases between the infiltrated La0.75Sr0.25Cr0.5Mn0.5O3 (LSCM) catalyst and the LSGM are observed at 900 °C. However, LaSrGa3O7, LaSrGaO4 and other unknown secondary phases are formed above the calcination temperature of 1000 °C when LSCM was infiltrated on porous LSGM scaffolds.The current (I)–voltage (V) characteristics are measured in an LSGM electrolyte single cell with a Ba0.5Sr0.5Co0.2Fe0.8O3-δ (BSCF) cathode and LSCM infiltrated into the LSGM scaffold type anode. The maximum power density of the single cell is 0.214 W cm− 2 at 800 °C.
