| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 1415717 | Carbon | 2011 | 12 Pages |
Tensile strength data of Al/CNT composites from the literature is analyzed to understand the effects of CNT dispersion, processing technique, degree of deformation and CNT–matrix interface on the elastic modulus, strength and toughness of composites. Strengthening can be divided in three regimes which show decreasing strengthening effect with an increasing CNT content. The strengthening is highest for CNT content less than 2 vol.%. The applicability of the micromechanics models in predicting the strength and elastic modulus of CNT reinforced metal matrix composites is also analyzed. The rule of mixtures is effective in predicting the elastic modulus of the Al/CNT composites for low CNT content (<2 vol.%) whereas Halpin–Tsai and combined Voigt–Reuss models are better at intermediate CNT content (2–5 vol.%). Effect of degree of deformation such as extrusion ratio during processing on the load transfer to CNT and resulting strengthening is also discussed. Tensile data on Cu/CNT and Mg/CNT composites is compared with Al/CNT to show that strengthening is not effective when there is no chemical interaction between metal matrix and CNT. The analysis presented here would be very helpful in the future design of high strength CNT/metal matrix composites.
Graphical abstractMicromechanics models applied to Al–CNT composites are evaluated for their applicability with respect to CNT concentration and processing technique. Rule of mixtures is effective in predicting the elastic modulus for low CNT content (<2 vol.%) whereas Halpin–Tsai and combined Voigt–Reuss models are better at intermediate CNT content (2–5 vol.%).Figure optionsDownload full-size imageDownload as PowerPoint slideResearch highlights► Strengthening efficiency of CNTs can be divided into three regimes of CNT content. ► Strengthening is highly dependent on CNT dispersion in powder mixture. ► Higher degree of deformation during processing leads to increased strengthening. ► CNT/matrix chemical interaction is essential for strengthening. ► Toughness decreases for high CNT content (>5 wt.%) and with poor dispersion.
