| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 1445119 | Acta Materialia | 2016 | 8 Pages |
Precipitation strengthening behavior during aging of an Al-0.014Sc-0.008Er-0.08Zr-0.10Si (at.%) alloy was investigated utilizing microhardness, electrical conductivity and scanning electron microscopy. This new composition, with a Sc/Zr ratio (in at.%) smaller than 1/5 represents a significant reduction of the alloy's cost, when compared to more usual Al-0.06Sc (at.%) based alloys with typical Sc/Zr ratios of 3. The research presented herein focuses on identifying the optimal homogenization duration at 640 °C and additionally the temperature range at which a single-step aging treatment will achieve the highest possible microhardness in the shortest time. Due to a compromise between dissolution of Er-Si rich primary precipitates, homogenization of the Zr distribution and precipitation of large Al3Zr precipitates, 8 h at 640 °C appears to be the optimal homogenization duration for this alloy, leading to an hardness of 571 ± 22 MPa after aging for 24 h at 400 °C. To study the precipitation behavior of this low-Sc concentration alloy, isochronal aging to 575 °C with two different heating rates was performed. The small Sc concentration, compensated by a high Zr concentration, permits the alloy to achieve a similar peak microhardness during isochronal aging (587 ± 20 MPa) as the corresponding Sc-richer and Zr-leaner alloys. The isochronal aging experiments permits us to identify the best aging temperature as between 350 and 425 °C.
Graphical abstractAs demonstrated by isochronal aging experiments, the newly developed low Sc alloy (Al-0.014Sc-0.008Er-0.08Zr-0.1Si at.%) achieves comparable hardness as the more expensive high Sc alloy (Al-0.055Sc-0.005Er-0.02Zr-0.05Si at.%) with 4 times more Sc.Figure optionsDownload full-size imageDownload high-quality image (310 K)Download as PowerPoint slide
