Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
1446620 | Acta Materialia | 2012 | 14 Pages |
Experiments were conducted to characterize the influence of texture and impact velocity on the dynamic, high-strain, tensile extrusion of zirconium. Bullet-shaped samples were machined from a clock-rolled, highly textured Zr plate. Specimens in two orthogonal directions were tested: the extrusion direction aligned with either the in-plane (IP) rolling or the through-thickness (TT) direction of the plate. The post-extrusion microstructure and texture evolution were examined using electron backscatter diffraction microscopy and modeled using the viscoplastic self-consistent model. It was found that extrusion deformation was accomplished through a combination of twinning and slip with their relative activity greatly depending on the initial texture. In this regard, higher elongations in the IP samples as compared to the TT samples were observed at similar test velocities. This difference in ductility is discussed in terms of the material’s ability to accommodate plastic deformation. Due to the availability of a larger number of slip systems with relatively high Schmid factors in the IP samples under this configuration, plastic deformation by prismatic slip can be easily achieved, resulting in larger elongations. On the contrary, for TT samples, twinning preceded deformation by slip. This sequential deformation process, driven by the need to reorient the microstructure favorably to slip, led to diminished elongations to failure.