Characterising wood fibre mats as reinforcements for liquid composite moulding processes

Liquid composite moulding (LCM) processes are commonly used techniques for the manufacture of advanced composite structures. This study explores the potential of wood fibres as reinforcement for LCM preforms, considering discontinuous fibre mats produced using four different methods. Modified paper manufacturing techniques were employed to produce two types of wet formed mats, the other two being manufactured using dry methods. The dry compaction response of these mats has been investigated, required compression loads being measured up to a fibre volume fraction of 0.4. A complex non-elastic compression response was observed which has significant influence on forces generated within moulds. Saturated compaction tests were also carried out, the samples infiltrated with two different test fluids. A significant reduction in compaction load was observed due to wood softening when using a water based fluid. On the other hand, a non-water-based solution had little less influence on the compaction of the wood fibre mats. In addition, permeability of all four types of mats was measured as a function of fibre volume fraction. Reinforcement permeability and compaction response data are required to simulate LCM processes.