Article ID Journal Published Year Pages File Type
1489001 Materials Research Bulletin 2013 5 Pages PDF
Abstract

•A semiconductor laser was first used to prepare wide-area LCVD-TiCx coatings.•The effect of laser power for the deposition of TiCx coatings was discussed.•TiCx coatings showed a columnar cross section and a dense surface texture.•TiCx coatings had a 1–4 order lower laser density than those of previous reports.•This study gives the possibility of LCVD applying on the preparation of TiCx coating.

A semiconductor laser-assisted chemical vapor deposition (LCVD) of titanium carbide (TiCx) coatings on Al2O3 substrate using tetrakis (diethylamido) titanium (TDEAT) and C2H2 as source materials were investigated. The influences of laser power (PL) and pre-heating temperature (Tpre) on the microstructure and deposition rate of TiCx coatings were examined. Single phase of TiCx coatings were obtained at PL = 100–200 W. TiCx coatings had a cauliflower-like surface and columnar cross section. TiCx coatings in the present study had the highest Rdep (54 μm/h) at a relative low Tdep than those of conventional CVD-TiCx coatings. The highest volume deposition rate (Vdep) of TiCx coatings was about 4.7 × 10−12 m3 s−1, which had 3–105 times larger deposition area and 1–4 order lower laser density than those of previous LCVD using CO2, Nd:YAG and argon ion laser.

Graphical abstractFigure optionsDownload full-size imageDownload as PowerPoint slide

Related Topics
Physical Sciences and Engineering Materials Science Ceramics and Composites
Authors
, , ,