Article ID Journal Published Year Pages File Type
1550705 Solar Energy 2012 11 Pages PDF
Abstract

In this paper, a performance and cost assessment of Integrated Solar Combined Cycle Systems (ISCCSs) based on parabolic troughs using CO2 as heat transfer fluid is reported on. The use of CO2 instead of the more conventional thermal oil as heat transfer fluid allows an increase in the temperature of the heat transfer fluid and thus in solar energy conversion efficiency. In particular, the ISCCS plant considered here was developed on the basis of a triple-pressure, reheated combined cycle power plant rated about 250 MW. Two different solutions for the solar steam generator are considered and compared.The results of the performance assessment show that the solar energy conversion efficiency ranges from 23% to 25% for a CO2 maximum temperature of 550 °C. For a CO2 temperature of 450 °C, solar efficiency decreases by about 1.5–2.0% points. The use of a solar steam generator including only the evaporation section instead of the preheating, evaporation and superheating sections allows the achievement of slightly better conversion efficiencies. However, the adoption of this solution leads to a maximum value of the solar share of around 10% on the ISCCS power output. The solar conversion efficiencies of the ISCCS systems considered here are slightly greater than those of the more conventional Concentrating Solar Power (CSP) systems based on steam cycles (20–23%) and are very similar to the predicted conversion efficiencies of the more advanced direct steam generation solar plants (22–27%).The results of a preliminary cost analysis show that due to the installation of the solar field, the electrical energy production cost for ISCCS power plants increases in comparison to the natural gas combined cycle (NGCC). In particular, the specific cost of electrical energy produced from solar energy is much greater (about two-fold) than that of electrical energy produced from natural gas.

► We evaluate performance and costs of combined cycles integrated with solar collectors. ► The use of CO2 as heat transfer in fluid parabolic trough collectors is studied. ► Net solar energy conversion efficiency ranges from 23% to 25%. ► Annual energy production increases by 1.5–2.0% with the introduction of solar section. ► Integration of combined cycle with solar energy increases Levelised Cost of Energy.

Related Topics
Physical Sciences and Engineering Energy Renewable Energy, Sustainability and the Environment
Authors
, , ,