Effect of Cr doping on the photoelectrochemical performance of hematite nanorod photoanodes

Hematite (α-Fe2O3) nanorod arrays modified by surface doping of chromium (III) ions (Cr3+) for photoelectrochemical (PEC) water splitting are fabricated using a general process involving a combination of aqueous chemical growth and spin coating. The PEC activity of Cr-doped α-Fe2O3 nanorod films first increases then decreases with increasing dopant content. At the optimal content of Cr, Cr-doped α-Fe2O3 nanorod films exhibit about 3.5 and 6 times higher PEC activity than the undoped material under solar light (AM 1.5, 100 mW cm−2) and visible light (λ>430 nm) irradiation, respectively. A comprehensive characterization of the chemical, morphological, PEC, structural, and optical properties of the doped α-Fe2O3 films are presented to assess the mechanisms by which the dopants influence photoelectrode performance. The relationship between dopant content, photoluminescence intensity, and PEC performance suggests Cr doping alters charge transfer in the films under irradiation. At low Cr doping contents, Cr dopants act as electron (or hole) traps and retard photoinduced charge recombination, leading to enhanced PEC activity. Whereas, at high Cr doping contents, Cr dopants act as charge recombination sites and lower the charge separation efficiency, leading to decreased PEC activity. High temperature annealing proves to be effective for further improvement of the PEC activities of doped and undoped hematite films, by Sn diffusion.

Graphical abstractFigure optionsDownload full-size imageDownload as PowerPoint slideHighlights► Surface composition of hematite nanorods was tuned by Cr3+ doping facilely. ► Doing of Cr3+ at a optimal concentration led to enhanced photoelectrochemical activity. ► Photoelectrochemical performances were promoted by altering photoinduced charge transfer ability.