| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 1570535 | Materials Characterization | 2016 | 10 Pages |
•Industrial waste fly ash was used to produce aluminum matrix composites.•Friction stir processing was used to produce AA6061/Fly Ash composite.•Fly ash particles refined the grains of aluminum matrix.•Fly ash particles enhanced the hardness and wear resistance.•Successful utilization of fly ash to make aluminum composites reduces land pollution.
Fly ash (FA) is a waste product of coal combustion in thermal power plants which is available in massive quantities all over the world causing land pollution. This paper reports the characterization of AA6061 aluminum matrix composites (AMCs) reinforced with FA particles synthesized using friction stir processing (FSP). The volume fraction of FA particles was varied from 0 to 18 in steps of 6. The prepared AMCs were characterized using optical microscopy (OM), scanning electron microscopy (SEM) and electron backscattered diagram (EBSD). The wear rate was estimated using a pin-on-disc wear apparatus. FA particles were observed to be distributed homogeneously in the AMC irrespective of the location within the stir zone. The EBSD micrographs revealed remarkable grain refinement in the AMC. The incorporation of FA particles enhanced the microhardness and wear resistance of the AMC. The strengthening mechanisms of the AMC were discussed and correlated to the observed microstructures. The wear mechanisms were identified by characterizing the wear debris and worn surfaces.
Graphical abstractFigure optionsDownload full-size imageDownload as PowerPoint slide
