Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
1573145 | Materials Science and Engineering: A | 2016 | 11 Pages |
Abstract
Lost Foam Casting (LFC) process is replacing the conventional gravity Die Casting (DC) process in automotive industry for the purpose of geometry optimization, cost reduction and consumption control. However, due to lower cooling rate, LFC produces in a coarser microstructure that reduces fatigue life. In order to study the influence of the casting microstructure of LFC Al-Si alloy on damage micromechanisms under monotonic tensile loading and Low Cycle Fatigue (LCF) at room temperature, an experimental protocol based on the three dimensional (3D) in-situ analysis has been set up and validated. This paper focuses on the influence of pores on crack initiation in monotonic and cyclic tensile loadings. X-ray Computed Tomography (CT) allowed the microstructure of material being characterized in 3D and damage evolution being followed in-situ also in 3D. Experimental and numerical mechanical fields were obtained by using Digital Volume Correlation (DVC) technique and Finite Element Method (FEM) simulation respectively. Pores were shown to have an important influence on strain localization as large pores generate enough strain localization zones for crack initiation both in monotonic tensile and cyclic loadings.
Related Topics
Physical Sciences and Engineering
Materials Science
Materials Science (General)
Authors
Long Wang, Nathalie Limodin, Ahmed El Bartali, Jean-François Witz, Rian Seghir, Jean-Yves Buffiere, Eric Charkaluk,