Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
1574846 | Materials Science and Engineering: A | 2014 | 8 Pages |
Abstract
The as-cast Ti44Al6Nb1.0Cr2.0V alloy master ingot was prepared by vacuum consumable melting technology. Some bars were cut from this ingot and they were directionally solidified by cold crucible under different pulling velocities. The samples could be well directionally solidified when the power (P) was 45 kW and the pulling velocity (V) was 8.33 μm/s or 11.67 μm/s. The results show that the interlamellar space of the directionally solidified samples decreases from the average 1650 nm of as-cast to less than 565 nm and is more homogeneous. The microcrack in the master ingot can be eliminated completely and the room temperature (RT) tensile property is also improved after cold crucible directional solidification (CCDS). The ultimate tensile strength (UTS) is 602.5 MPa and the elongation is 1.20% as P=45 kW and V=11.67 μm/s, compared with as-cast 499 MPa of UTS and 0.53% of elongation. Trans-granular and trans-lamella fractures are predominant modes. The relationship between CCDS interlamellar space (d) and the pulling velocity can be described as d=1783.2Vâ0.554 and r12=0.972, where r12 is the corresponding regression coefficient. The CCDS interlamellar space and nanoindentation hardness (HN) in the lamella region can be described as HN=17.95dâ0.145 and r22=0.986, and they are changed as HNâ²=14.03dâ²â0.104 and r32=0.975 when the cast condition is considered. The nanoindentation hardness of the B2 phase and the block γ phase are about 8.89 GPa and 8.15 GPa, respectively; both of them keep almost the same in different conditions.
Keywords
Related Topics
Physical Sciences and Engineering
Materials Science
Materials Science (General)
Authors
Shulin Dong, Ruirun Chen, Jingjie Guo, Hongsheng Ding, Yanqing Su, Hengzhi Fu,