Article ID Journal Published Year Pages File Type
1575917 Materials Science and Engineering: A 2013 6 Pages PDF
Abstract

The microstructures and tensile properties of two ultrafine structured Cu–5vol%Al2O3 nanocomposite samples made by a combination of high energy mechanical milling of a mixture of Cu powder and gamma Al2O3 nanopowder and powder compact extrusion were studied. The sample extruded at 750 °C exhibited a microstructure consisting of Cu grains with sizes in the range of 100–500 nm and a dispersion of Al2O3 nanoparticles with sizes in the range of 20–345 nm. With the extrusion temperature increasing to 900 °C, the Cu grain sizes remained almost unchanged, but a large fraction of the Al2O3 nanoparticles were dissolved, leading to possible formation of nanometer sized Al3+/O2− clusters. This microstructural difference of the two samples causes an interesting difference in tensile properties, with the sample extruded at 900 °C showing approximately 150 MPa higher yield strength and ultimate tensile strength and also better ductility than the sample extruded at 750 °C. It appears that this significant beneficial effect of dissolution of Al2O3 nanoparticles is mainly caused by the significant strengthening effect of the nanometer sized Al3+/O2− clusters through Orowan mechanism.

Related Topics
Physical Sciences and Engineering Materials Science Materials Science (General)
Authors
, , , ,