| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 1578240 | Materials Science and Engineering: A | 2011 | 5 Pages |
In this work, SPB of duplex stainless steel (DSS) under compression method is studied with the objective to produce ultra hard and thick boronized layer using minimal amount of boron powder and at a much faster boronizing time as compared to the conventional process. SPB is conducted under dual compression methods. In the first method DSS is boronized using a minimal amount of boron powder under a fix pre-strained compression condition throughout the process. The compression strain is controlled in such a way that plastic deformation is restricted at the surface asperities of the substrate in contact with the boron powder. In the second method, the boronized specimen taken from the first mode is compressed superplastically up to a certain compressive strain under a certain strain rate condition. The process in the second method is conducted without the present of boron powder. As compared with the conventional boronizing process, through this SPB under dual compression methods, a much harder and thicker boronized layer thickness is able to be produced using a minimal amount of boron powder.
► Superplastic boronizing. ► Dual compression method has been developed. ► Hard boride layer. ► Bulk deformation was significantly thicker the boronized layer. ► New data on boronizing could be expanded the application of DSS in industries.
