Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
1581010 | Materials Science and Engineering: A | 2009 | 8 Pages |
Abstract
AZ91D magnesium alloy semi-solid billets prepared by the strain-induced melt activation (SIMA) process have been proposed or reported in previous literature. However, no detailed investigation has been conducted regarding Mg-Zn-Zr series magnesium alloys. In this paper, the microstructural evolution of ZK60 magnesium alloy with a rare earth (RE) addition during partial remelting has been studied. Equal channel angular extrusion (ECAE) was introduced into the SIMA process to replace conventional upset or extrusion. The results show that as-cast ZK60-RE magnesium alloys are successfully extruded by ECAE. The semi-solid microstructure of ECAE-formed ZK60-RE consists of fine and spheroidal grains surrounded by grain boundary liquid films. The cubic coarsening rate constant, K, increases from 255 to 371 μm3 sâ1 when the solid fraction decreases from 0.75 (600 °C) to 0.65 (615 °C). With increasing numbers of ECAE passes, which means increasing distortion energy, grain sizes are finer and liquid formation rates are enhanced. This kind of research encourages the belief that the combination of ECAE and partial remelting in the semi-solid state can produce magnesium alloy semi-solid billet with fine and spheroidal grains, which is suitable for semi-solid processing.
Related Topics
Physical Sciences and Engineering
Materials Science
Materials Science (General)
Authors
Zude Zhao, Qiang Chen, Yanbin Wang, Dayu Shu,