Effect of loading rate on the monotonic tensile behavior and tensile strength of an oxide–oxide ceramic composite at 1200 °C

The influence of loading rate on monotonic tensile behavior and tensile properties of an oxide–oxide ceramic composite was evaluated in laboratory air at 1200 °C. The composite consists of a porous alumina matrix reinforced with woven mullite/alumina (Nextel™720) fibers, has no interface between the fiber and matrix, and relies on the porous matrix for flaw tolerance. Tensile tests conducted at loading rates of 0.0025 and 25 MPa/s revealed a strong effect of rate on the stress–strain behavior as well as on the ultimate tensile strength (UTS), elastic modulus and failure strain. At 0.0025 MPa/s, increase in stress results in non-monotonic change in strain, with the rate of change of strain reversing its sign at stresses ∼25 MPa/s. Several samples were subjected to additional heat treatments prior to testing in order to determine whether this unusual stress–strain behavior was an artifact of incomplete processing of fibers in the as-received material. The unusual material response in the 0–30 MPa stress range was further investigated in creep tests conducted with the applied stresses ≤26 MPa. Negative creep (i.e. decrease in strain under constant stress) was observed. Porosity measurements indicate that a decrease in matrix porosity and matrix densification may be taking place in the N720/A composite exposed to 1200 °C at stresses <30 MPa for prolonged periods of time.