Computational fluid dynamics (CFD) modeling of spouted bed: Influence of frictional stress, maximum packing limit and coefficient of restitution of particles

Following the previous article [Du, W., Bao, X., Xu, J., Wei, W., 2006. Computational fluid dynamics (CFD) modeling of spouted bed: assessment of drag coefficient correlations. Chemical Engineering Science 61 (5), 1401–1420], this contribution describes the influences of the frictional stress, maximum packing limit and coefficient of restitution of particles on CFD simulation of spouted beds. Using the two-fluid method embedded in the commercial CFD simulation package Fluent 6.1, the spouting hydrodynamics of a cylindrical–conical spouted bed was simulated and verified with the experimental data of He et al. [He, Y.L., Lim, C.J., Grace, J.R., Zhu, J.X., Qin, S.Z., 1994a. Measurements of voidage profiles in spouted beds. Canadian Journal of Chemical Engineering 72 (4), 229–234; He, Y.L., Qin, S.Z., Lim, C.J., Grace, J.R., 1994b. Particle velocity profiles and solid flow patterns in spouted beds. Canadian Journal of Chemical Engineering 72(8), 561–568]. The results showed that, for coarse particles, the frictional stress is important only for the annulus computation and has no obvious effects on the hydrodynamics of the solids flow in the spout region. The specification of the maximum packing limit could significantly affect the properties of the pseudo-fluid phase of the particles by changing the radial distribution function. The strong dependence of the pseudo-fluid properties of the particle phase, such as pressure, bulk viscosity and shear viscosity, on the granular temperature accounts for the influence of the coefficient of restitution of particles on CFD modeling. The solids volume fraction at loose packing state is suitable for spouted bed simulations, and a pretest of the coefficient of restitution of particles must be conducted when no experimental datum is available.