Purification of solar cell silicon materials through filtration

Silicon is the material most commonly used in the manufacturing of photovoltaic (PV) cells. In the current study, laboratory experiments of purification of solar cell silicon materials through filtration are carried out. Inclusion removal from silicon was investigated. The purpose is to achieve clean silicon materials for solar cells. Silicon samples and filter samples were analyzed using microscope observation, EPMA, and X-ray detection. Silicon nitride (Si3N4) and silicon carbide (SiC) particles are the main non-metallic inclusions present in top-cut silicon scrap. Almost all inclusions larger than 10 μm can be removed from silicon by the porous foam filter. In mass fraction, more than 90% inclusions are removed. Si3N4particles are mainly removed on the top surface of the filter, and SiC particles are mainly removed by entering the pores and attaching to the filter material. SiC inclusions are not only simply attached on the surface of the filter material, but are found also inside the filter material. There are SiC bridges near the filter materials. These bridges may fill the spaces between filter material, and this will further retard inclusions passing through the filter. Three-dimensional turbulent fluid flow and inclusion motion in the filter was calculated. Both experimental observation and fluid flow simulation indicate that most of the inclusions are entrapped at the upper part of the filter.