High temperature behavior of functional TiAlBSiN nanocomposite coatings

•Multielement amorphous TiAlBSiN coatings were grown by means of DC magnetron sputtering.•Structural and morphological transformations of the amorphous coatings after annealing at 900 °C in air were analysed.•Tribo-mechanical properties of the coatings at nano- and microscale were characterized.•The improvement of the coating properties in response to the environmental conditions and high temperature is reported.

This article reports on the thorough characterization of structural-phase transformation in amorphous TiAlBSiN coating after high temperature annealing at 900 °C in ambient air. The influence of annealing on the tribo-mechanical behavior of the coating at nano and micro scale was also examined. The research included multiple experimental techniques, i.e. AFM, SEM, TEM, HR-TEM, EDS, XPS and Raman spectroscopy. Experiments showed that the amorphous phase of the TiAlBSiN coating undergoes a structural transformation, evidenced in the changes of parameters such as topological and chemical short-range order after the post-deposition annealing at 900 °C in air. The observed structural transformation, leads to a phase separation with the formation of a three dimensional nc-TiAl3/a-SiBN(O) nanocomposite structure. The relative increase of hardness, reduced elastic modulus, H/Er ratio and H2/E3r ratio after high temperature treatment of TiAlBSiN coatings is also reported. The complex interdependency between chemistry, morphology and relative composition of the amorphous TiAlBSiN coating phase, during the high temperature treatment, with the respective change of the tribo-mechanical characteristics, are evidence of the improvement of the coating properties in response to the environmental conditions and high temperature. This work contributes particularly to the development and understanding of flexible nanocomposite protective coatings and their changes at high temperature of operation.