Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
1659113 | Surface and Coatings Technology | 2010 | 7 Pages |
The phase transformation of hydrogen-free amorphous carbon (a-C) coating on tungsten high speed steel (SKH2) substrates under repetitive impact testing has been studied. The a-C coated disc was impacted by the chromium molybdenum steel (SCM420) pin at several different impact loads and impact cycles (up to 100,000) under lubricated conditions. The results show that the sp3 fractions of impacted a-C coating obtained from the surface of impact craters are significantly increased with impact cycles due to decreasing ID/IG ratio. This means that the amorphization of a-C coating also increased after several impact cycles. As for the full-width at half maximum (FWHM) of G peak characterization, it is shown that the hardness of impacted a-C coating is higher than the as-received. From the observation of surface roughness using atomic force microscopy (AFM), it is supposed that increasing sp3 fractions and the hardness of the impacted a-C coating during impact correlate to the reduction of surface roughness. In addition, the tribochemical reaction to the environment during impact occurred at the mating material, where the transfer layer adhered, as well as in the wear debris. This is due to the oxidation of ferrum (Fe) to magnetite (Fe3O4) and hematite (α-Fe2O3) phases with predominant peak at about 680 cm−1 and 1317 cm−1, respectively. The formation of Fe3O4 and α-Fe2O3 phases was revealed from Raman spectroscopy and the existence of oxide elements was verified by energy dispersive X-ray spectroscopic (EDS) analysis. Increasing the G peak position, together with a concomitant decrease of their width, it is believed that the structural transformation from sp3 to sp2 is taking place within the wear debris and leads to the graphitization process at a higher contact pressure. It was suggested that the high contact pressure is not just only corresponding to the applied normal impact load, but it is also exerted by an oil lubricant during impact. A high contact pressure can significantly reduce the graphitization temperature and substantially accelerate the graphitization process. However, a significant phase transformation of the transfer layer on the SCM420 pin does not intensely occur because it is mainly coming from the surface layer of the impacted a-C coating, where the sp3 content increases and no wear debris is observed inside it.