Preparation of high quality polycrystalline silicon thin films by aluminum-induced crystallization

High quality polycrystalline silicon (poly-Si) thin films without Si islands were prepared by using aluminum-induced crystallization on glass substrates. Al and amorphous silicon films were deposited by vacuum thermal evaporation and radio frequency magnetron sputtering, respectively. The samples were annealed at 500 °C for 7 h and then Al was removed by wet etching. Scanning electron microscopy shows that there are two layers in the thin films. After the upper layer was peeled off, the lower poly-Si thin film was found to be of high crystalline quality. It presented a Raman peak at 521 cm− 1 with full width at a half maximum of 5.23 cm− 1, which is similar to c-Si wafer.