Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
1671960 | Thin Solid Films | 2009 | 9 Pages |
Abstract
Changes in the functional properties of 50 and 100Â nm thick anatase-type and of 100 and 150Â nm thick rutile-type atomic-layer-deposited TiO2 coatings with increasing tensile deformation of AISI 304 stainless steel substrate up to 40% strain were studied. All as-received coatings exhibited good photoelectrochemical and photocatalytic activity as well as photohydrophilicity, but the photocatalytic activity of the rutile-type coatings was only one third of that of the anatase-type coatings. The deformation induced changes in the functional properties depended strongly on the type and thickness of the coating. For the 50Â nm anatase-type coating, all the monitored functional properties were severely reduced when the applied strain was 1.4% and higher. Rest of the coatings showed also considerable, but more gradual, decrease of the photoelectrochemical and photocatalytic activity with increasing strain. Least affected was the photohydrophilicity which remained approximately constant until 30% applied strain for the 100Â nm coatings, and showed some variation for the 150Â nm coating. The possible reasons for the observed behavior are discussed.
Keywords
Related Topics
Physical Sciences and Engineering
Materials Science
Nanotechnology
Authors
Ladislav Straka, Hiroshi Kawakami, Jyrki Romu, Risto Ilola, Riitta Mahlberg, Mikko Heikkilä, Hannu Hänninen,