| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 1679905 | Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms | 2015 | 8 Pages |
A procedure to measure molybdenum and tungsten contamination in implantation processes by DLTS (Deep Level Transient Spectroscopy) is defined and calibrated for the evaluation of molybdenum and tungsten contaminant dose. The obtained calibrations are used to study molybdenum contamination in BF2 implantations and tungsten contamination by sputtering from a previously contaminated wafer holder.In molybdenum-implanted samples, the molybdenum level located 0.3 eV above valence band is revealed only. In tungsten-implanted samples, two levels are revealed. One of these levels is the tungsten-related hole trap located 0.4 eV above valence band. The other level does not correspond to any tungsten-related level, however it is related to the presence of tungsten and to the sample preparation process. The SPV (Surface Photovoltage) measurement sensitivity to tungsten contamination was also tested, and it was found much lower than the DLTS sensitivity, due to the low tungsten diffusivity.This procedure was used to evaluate contamination in implantation processes. In BF2 implantations, in addition to molybdenum, tungsten contamination is found. Molybdenum and tungsten contamination is found in boron implantation too.The tungsten contamination induced by implantation in a previously contaminated implanter was quantified, and the efficiency of arsenic implantation as a decontamination process was tested. Finally, it was shown that TXRF (Total reflection X-ray Fluorescence) is much less sensitive than DLTS for monitoring tungsten contamination.
