Combination of gettering and etching in multicrystalline silicon used in solar cells processing

Undesired impurities can be removed away from multicrystalline silicon (mc-Si) wafers by combining porous silicon (PS) formation and heat treatments. The gettering procedure used in this work is based on the formation of a PS film at both back and front sides of the mc-Si wafers, followed by a heat treatment. The latter was achieved in an infrared furnace at different temperatures and during various periods. We show that when the based material undergoes such a gettering, the electrical properties (short-circuit current, open-circuit voltage, serial and shunt resistances) and the electronic parameters (diffusion length and grain boundary recombination velocity) of the corresponding solar cells can be improved only if some regions of the wafers are etched. Compared to reference cells based on untreated wafers, the diffusion length and grain boundary recombination velocity of solar cells fabricated from gettered and etched samples was improved by about 30% and reduced by a factor of 10, respectively.