A theoretical approach to indoor radon and thoron distribution

A model based on the Finite Element Method was developed to simulate indoor behavior of radon (222Rn), thoron (220Rn) and their progeny, as well as, to calculate their spatial distributions. Since complex physical processes govern the distribution several simplifications were made in the presented model. Different locations of possible radon/thoron sources, diffusion of these gases, their radioactive decay, etc were taken into account. Influences of different parameters on thoron/radon as well as indoor distribution of their progeny, such as the geometry and room dimension, the presence of aerosols and their size distribution expressed through the diffusion coefficient, different kinds of ventilation, etc, were investigated. It has been found that radon is distributed homogeneously, while the thoron concentration is rather inhomogeneous and decreases exponentially with the distance from the source. Regardless of the source distribution, the distribution of radon was homogeneous, except at places near an air inlet and outlet. However, the distribution of thoron depends on the source distribution. If thoron emanates from walls or the floor, its concentration decreases with the distance from the wall. Moreover, the concentration gradient is much larger near walls. This suggests that the actual selection of the site effect should be taken into account when obtaining a representative value of indoor 220Rn and their progeny for dose assessment. The simulation results of activities and their distribution were in accordance with the results of other studies and experiments.