| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 1830922 | Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment | 2007 | 11 Pages |
Lanthanum bromide (LaBr3:Ce) scintillators offer significantly better resolution (<3 percent at 662 keV) relative to sodium iodide (NaI(Tl)) but contain internal radioactivity that contributes to spectral counts. LaBr3:Ce has recently become available commercially in sizes large enough for the hand-held radio-isotope identification device (RIID) market. To study its potential for RIIDs, a series of measurements were performed comparing a 1.5×1.5-in. LaBr3:Ce detector with an Exploranium GR-135 RIID, which contains a 1.5×2.2-in. NaI(Tl) detector. Measurements were taken for short time frames and included examples of naturally occurring radioactive material (NORM), typically found in cargo, and special nuclear materials. To facilitate direct comparison, spectra from the different detectors were analyzed with the same isotope identification software (ORTEC ScintiVision™). In general, the LaBr3:Ce detector was able to find more peaks and find them faster than the NaI(Tl) detector. To the same level of significance, the LaBr3:Ce detector was usually two to three times faster. The notable exception was for 40K-containing NORM where interfering internal activity due to 138La in the LaBr3:Ce detector exists and NaI(Tl) consistently outperformed LaBr3:Ce.
