Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
185352 | Electrochimica Acta | 2014 | 6 Pages |
•Added value to using ternary and quaternary compounds as source materials.•Ability to deposit binary compound film electrodes with only one parameter to control.•Offering new option to enhance PEC conversion efficiency of film electrode.
Addition of argon gas, with different flow rates, to vacuum evaporation deposition of film electrodes from Cu2SnSe3 source, affect nature and properties of the resulting films. While keeping other factors constant, it is possible to control nature and properties of the resulting films simply by controlling the argon gas flow rate. This work shows that films deposited from Cu2SnSe3 under high argon gas flow rate (25 cm3/min) involved SnSe as a major compound, with low concentration of Cu dopant. The film showed higher photoresponse than those deposited from pristine SnSe source. Under lower argon gas flow rates, the resulting films were dominated by the ternary source compound itself, which also showed lower photoresponse than that deposited under higher flow rate. Structure, morphology, chemical composition, optical and photo-electrochemical characteristics have all been studied for films deposited from Cu2SnSe3 under different argon gas flow rates, in parallel with earlier films deposited from SnSe and Cu2ZnSnSe4. The films deposited from Cu2SnSe3 or Cu2ZnSnSe4 under high argon gas flow rate showed a p-type semiconductor behavior with energy gap of about 1.0 eV which confirms the existence of SnSe as a dominant component in each case. A mechanism, which is mainly based on a model of elastic collisions, is proposed to explain the production of SnSe films from the ternary and quaternary sources. On the other hand, the presence of low concentrations of Cu or/and Zn species in the resulting SnSe films is presumably responsible for enhanced photoresponse, as compared to films deposited from pristine SnSe.
Graphical abstractThe PEC characteristics measured for films deposited under different argon gas flow rates (a) 5, (b) 10, (c) 15, and (d) 25 cm3/min.Figure optionsDownload full-size imageDownload as PowerPoint slide