Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
194794 | Electrochimica Acta | 2006 | 4 Pages |
Abstract
Ti–Si alloys with the nominal composition of Ti14Si86, Ti16Si84, Ti21Si79 were rapidly solidified using a single roller melt spinning technique. The melt-spun Ti–Si ribbon powders were mechanically milled with graphite powders, followed by the carbon coating through pyrolysis of coal tar pitch at 900 °C under argon flow. These composite electrodes exhibit good cycle performance, especially when the Si content in the Ti–Si alloy is below the composition of the Si + TiSi2 eutectic.
Related Topics
Physical Sciences and Engineering
Chemical Engineering
Chemical Engineering (General)
Authors
Yoo-Sung Lee, Jong-Hyuk Lee, Yeon-Wook Kim, Yang-Kook Sun, Sung-Man Lee,