Article ID Journal Published Year Pages File Type
209086 Fuel Processing Technology 2016 9 Pages PDF
Abstract

•Mercury content was studied in 121 subbituminous coal and 30 lignite samples.•Mercury emission potential was estimated for Polish subbituminous coal and lignite.•Mercury balance was calculated for three Polish power plants.•Mercury removal efficiency in Air Pollution Control Devices was determined.•We calculated mercury emission factors for combustion of coal and lignite.

Coal combustion is one of the main anthropogenic sources of mercury emission to the atmosphere. A total of 121 subbituminous coal samples and 29 lignite samples representative for coals burned in Polish power and heat and power plants were acquired and examined. The average mercury content in subbituminous coal samples was 104 μg kg− 1 (4.591 g Hg TJ− 1), varying from 18 to 518 μg kg− 1. The average chlorine and bromine content were 2200 ppm and 12 ppm, respectively. For lignite samples the average mercury content was 197 μg kg− 1 (21.380 g Hg TJ− 1), varying from 60 to 665 μg kg− 1. Lignite samples contained significantly less chlorine (40 ppm on average) and bromine (4 ppm) than coal samples. The Cl·Hg− 1 ratio for subbituminous coal samples varied between 103 and 105. For lignite samples this ratio was around 10. Mercury mass balances were performed for two subbituminous coal-fired plants and one lignite-fired plant. The chemical composition of each type of coal had a significant influence on mercury concentration and speciation in the flue gas. The proportion of oxidized mercury (Hg2 +) correlated with chlorine content. The relatively large proportion of particulate-bound mercury (Hgp) and Hg2 + measured favored mercury removal by the electrostatic precipitator (65% on average), and by the wet flue gas desulfurization units (32%). Results of mercury emissions from the stack to the atmosphere were 2.0–5.0 and 15.1 μg m− 3, for plants burning subbituminous coal and lignite, respectively. The mercury leaving the stack from three plants was over 90% elemental mercury (Hg0). Calculated mercury emission factors for plants burning subbituminous coal and lignite were: 0.71–1.80 g Hg TJ− 1 (subbituminous coal) and 6.09 g Hg TJ− 1 (lignite).

Related Topics
Physical Sciences and Engineering Chemical Engineering Chemical Engineering (General)
Authors
, , , ,