Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
214675 | International Journal of Mineral Processing | 2006 | 14 Pages |
This paper presents the experimental results of the mechanical production of silica and carbonate colloidal particles below 100 nm using two types of stirred bead mills (i.e., DCP Superflow 12 and PML H/V). It is shown that the stirred bead mill with very small beads can be used as an efficient equipment for the production of the colloidal particles in nanoscale from the feed materials of several microns in sizes at high energy consumptions. The DCP Superflow mill with high power densities is superior for the effective size reduction and production rate, compared to the conventional PML H/V mill with lower power densities. The smaller particles could be produced by the DCP Superflow mill at the same level of high energy inputs as from the PML H/V mill. The “grinding limit” for the processes in the mills has been discussed.The nanoparticle sizes of the ground products obtained in the mills were determined by a scanning mobility particle sizer (SMPS), an acoustic particle sizer (APS-100), a nitrogen gas adsorption method (BET), and transmission electron microscopy (TEM). The surface mean particle diameters on the same sample obtained with the different methods for the nanoparticle size analysis are varying due to the different characterisation techniques. The TEM micrographs show a large amount of the primary nanoparticles below 100 nm produced after milling.In addition, the surface and structure of the original and the ground colloidal products have been investigated with some particle/surface characterisation techniques such as X-ray diffraction (XRD), nuclear magnetic resonance (29Si NMR) and Fourier transform infrared spectroscopy (FTIR). It is indicated that an intense comminution of carbonate minerals in the stirred bead mills leads to a progressive loss in crystallinity of the basal planes of the crystal structure. An intensive mechanical treatment of silica gives the structural changes and the amorphisation.