Suitability of bentonite-paste tailings mixtures as engineering barrier material for mine waste containment facilities

This study investigates the feasibility of using bentonite-paste tailings (BPT) as a barrier (liner, cover) material for mine waste containment facilities. Improvements of the hydraulic properties are realized by using compaction to densify the paste tailings in the first stage and mixing an additive-like natural bentonite to paste tailings to further reduce the voids that control hydraulic conductivity in the second stage. A significant decrease in hydraulic conductivity is observed with these transformations. Values that are as low as 1 × 10−9 and 4 × 10−9 cm/s are obtained in 8% and 4% bentonite and BPT, respectively. Based on these satisfactory values, additional investigations are conducted to evaluate the freeze–thaw and wet–drying performance of BPT up to 5 and 6 cycles, respectively. The results show that negligible to acceptable changes in hydraulic conductivity occur. None of the changes reach one order of magnitude. As a final step, a cost analysis is undertaken to evaluate the economical benefits that can be obtained from such new material. When compared to conventional compacted clay–bentonite barrier or sand–bentonite with 12% bentonite concentration, it is found that the 4% BPT is less expensive by 66%. The results place this recycled BPT material as a promising candidate for barrier design while reducing the amount of waste to be managed and the cost of surface tailings management.