Article ID Journal Published Year Pages File Type
239079 Powder Technology 2008 9 Pages PDF
Abstract

An electrical-impedance tomography (EIT) system has been developed to non-invasively measure radial voidage profiles in the riser of a pilot-scale circulating fluidized bed (CFB), yielding quantitative information that is validated by comparison to a gamma-densitometry tomography (GDT) system. EIT and GDT were applied to the CFB riser (14-cm inner diameter, 5.77-m height) containing fluid catalytic cracking particles in air. For all cases, the average and near-wall voidages from EIT and GDT agreed to within 0.03 and 0.07, respectively. This good agreement suggests that, where feasible, EIT can be used in place of GDT, which is advantageous since EIT systems are often safer, less expensive, and faster than GDT systems. The results also compared well to two correlations for radial voidage profile from the literature. Finally, a procedure for determining radial solids flux profiles from radial voidage profiles using an additional correlation [M.J. Rhodes, X.S. Wang, H. Cheng, T. Hirama, B.M. Gibbs, Similar profiles of solids flux in circulating fluidized-bed risers, Chemical Engineering Science 47 (1992) 1635–1643] was investigated. It was found that the accuracy of this correlation strongly depends on the voidage and/or solids flux measurement at the riser center.

Graphical abstractAn electrical-impedance tomography system for the measurement of radial voidage profiles in the riser of a circulating fluidized bed is validated against a gamma-densitometry tomography system. Measurements from the systems compare favorably with each other and with two literature correlations, and an additional literature correlation for determining radial solids flux profiles from radial voidage profiles is demonstrated.Figure optionsDownload full-size imageDownload as PowerPoint slide

Related Topics
Physical Sciences and Engineering Chemical Engineering Chemical Engineering (General)
Authors
, , , , ,