Required unfactored strength of geosynthetics in reinforced 3D slopes

The design of reinforced earth structures uses idealized two-dimensional (2D) geometry – classifying as a plane-strain analysis. This 2D idealization greatly simplifies design by ignoring stabilizing effects posed by three-dimensional (3D) characteristics. While the outcome of this 2D idealization is conservative in terms of required reinforcement strength, ignoring 3D end effects in back-calculations of experimental and field data may overestimate the contribution of the reinforcement to stability thus possibly leading to unconservative learned lessons related to design. The objective of this study is to explore 3D effects on the required strength of reinforcement in geosynthetic-reinforced earth structures (GRESs) using a modified 3D limit equilibrium (LE) slope stability analysis. To determine the stability of GRESs, a rotational, 3D failure mechanism, derived from variational LE analysis, is applied using a log-spiral surface generalized to 3D conditions. In order to determine the long-term strength of geosynthetics required to ensure sufficient internal stability, the moment equilibrium approach is applied and its respective equations solved. In order to conveniently assess the end effects on the required total strength of reinforcement and the volume of failing mass considering the feasible length of potential failure, a series of design charts are presented. These charts can also be useful in forensic studies when back-calculating the in-situ mobilized strength of the geosynthetic for 3D failures. The impact of seismicity and the assumed function of forces distributed amongst the reinforcement layers were investigated to highlight their importance. To keep this study focused on 3D end effects, this study is limited to a simple 3D GRES problem; however, extending the present framework to deal with complex homogenous problems is straightforward.