| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 296519 | Nuclear Engineering and Design | 2014 | 10 Pages |
•46 void fraction correlations are evaluated on void fraction.•Evaluation of void fraction correlations on slug velocity is studied.•Effect of void fraction correlations on separated frictional pressure drop is studied.•Drift-flux type correlation shows best agreement with experimental data.•Evaluation is investigated in different flow regions.
A visualized investigation was conducted on inclined upward air–water slug flow in a narrow rectangular duct with the cross section of 43 mm × 3.25 mm. The slug velocity and void fraction were obtained through image processing. 46 correlations for predicting void fraction, covering the types of slip ratio, Kβ, Lockhart and Martinelli, drift-flux and general were evaluated against the experimental data. In the experiment, four inclined conditions including 0°, 10°, 20° and 30° were investigated and the ranges of gas and liquid superficial velocity were 0.16–2.63 m/s and 0.12–3.59 m/s, respectively. The results indicate that the inclination has no significant influence on prediction error for a given correlation and the drift-flux type correlations are more competitive than the others in the prediction of slug velocity and void fraction. In addition, most of drift-flux type correlations are quite accurate in turbulent flow region, while they provide relative poor predictions in laminar flow region. As for the frictional pressure drop separated from the measured total pressure drop, the deviation arising from the calculation of the void fraction by different correlations is significant in laminar flow region, whereas is negligible in turbulent flow region.
