Basic investigations on debris cooling

An experimental investigation of boiling phenomena in inductively heated particle beds has been performed. The major aim of these experiments is to provide data for validating numerical codes used in reactor safety. The experiments can be divided in three parts: boiling experiments, dryout experiments and quenching experiments. In boiling experiments, the pressure gradients have been measured along the bed height for different flow modes, different heat inputs and different system pressures. In dryout experiments, the minimum heat input has been determined for which the particle bed starts to superheat significantly above the saturation temperature. The final test series deals with the cool down behaviour of strongly superheated particles by flooding them with cold water. The initial temperatures ranged from 200 up to 900 °C in top-quenching experiments and from 230 up to 450 °C in bottom-quenching experiments. All experiments were performed with pre-oxidised stainless steel balls of 6 and 3 mm diameter in a cylindrical crucible. The bed height was 640 mm and the bed diameter was 125 mm for boiling and dryout experiments, respectively 150 mm for quenching experiments. The experimental results are compared with various available dryout models.