Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
300385 | Renewable Energy | 2013 | 8 Pages |
The road testing and demonstration of a three-wheeler vehicle driven by a 5 kW proton exchange membrane fuel cell (PEMFC) was carried out in the absence and presence of lead acid batteries. Prior to integrating the PEMFC module and batteries in the three-wheeler, they were tested and demonstrated separately. The PEMFC module had a very fast response as the load was manually or, especially, automatically changed and it could supply a continuous power when the reactant was supplied continuously. In contrast, the 5 kW lead acid batteries alone could supply power for no longer than 300 s. In the presence of both the PEMFC module and batteries, when the drawing power was in the range of the PEMFC module capacity the propulsion motor gained its energy from the PEMFC module only, whilst the stack power output at all conditions was greater than the setting power of approximately 400 W. After integrating the PEMFC module and batteries into the three-wheeler, both energy sources were found to power the vehicle effectively. The motor power as well as the stack power changed as a linear proportion to the throttle. The motor consumed more power in case of high speed driving, take off or hill climbing, while it used only 0.354 kW in the absence of throttle. The hybrid system can achieve a maximum speed in this three-wheeler of around 24.9 km/h with a hydrogen consumption of 11 g H2/km (71 g H2/kWh) and an operating cost of 1.99 USD/km. The thermodynamic efficiency of the vehicle was 42.9%.
► 5 kW PEM fuel cell was installed in parallel circuit with batteries in a tricycle. ► The vehicle was tested and collected the data. ► The performance under the integration of batteries and fuel cell was observed. ► The fuel consumption and the efficiency of the fuel cell were determined.