| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 300540 | Renewable Energy | 2013 | 7 Pages |
The use of Al2O3 fabricated by atomic layer deposition (ALD) as a metal diffusion barrier between the stainless steel substrate and the back contact layer in flexible Cu(In,Ga)Se2 (CIGS) photovoltaic (PV) devices was found to reduce metal ion diffusion from the substrate and reduce the number of defects at the CIGS absorber layer, as determined from the secondary ion mass spectrometry (SIMS) depth profile and quantitative defect analysis using C–V measurements. Cells with Al2O3 barrier layers were found to show higher efficiency and uniformity compared to cells with ZnO barrier layers. XRD pattern analysis showed the Al2O3 barrier layer's amorphous characteristic which can form a complex diffusion path. In addition, quantum efficiency (QE) analysis of the cells showed that the main advantage of using an Al2O3 barrier layer is derived from the increase in the current density due to the decrease in the number of recombination sites resulting from the decrease in the number of defects due to the amorphous nature of the layer. Therefore, cells with an Al2O3 barrier layer fabricated by ALD showed better average conversion efficiency and uniformity (11.23 ± 1.86%) compared to cells with a ZnO barrier layer fabricated by sputtering. Ongoing advancements in ALD processes make the use of Al2O3 barrier layers promising for obtaining large-scale flexible solar cells.
► Al2O3 diffusion barriers were fabricated by atomic layer deposition for Cu(In,Ga)Se2 solar cells. ► Diffusion of Fe ions reduced approximately 95% by using 300 nm Al2O3 barrier layer. ► Reduction of defect density was measured by capacitance–voltage measurements (C–V). ► Maximum light conversion efficiency of cell was 13.44%. ► Average efficiency of cells on 100 cm2 substrate was 11.23 ± 1.86%.
