| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 301209 | Renewable Energy | 2011 | 7 Pages |
A new type of thermoelectric generator (TEG) system based on liquid metal which serves to harvest and transport waste heat, is proposed in this paper. To demonstrate the feasibility of the new TEG system, an experimental prototype which combined commercially available thermoelectric (TE) modules with the electromagnetic pump was set up. Output voltage from TE modules and temperature changes of the main parts (waste heat source, liquid metal heating plate, water-cooling plates I and II) of the liquid metal based TEG system were experimentally measured, as well as the flow rate of cooling water and the load resistance. It was shown that the maximum open-circuit voltage of 34.7 V was obtained when the temperature of the waste heat source was 195.9 °C and the temperature gap between liquid metal heating plate and cooling-water plates was nearly 100 °C. These experimental results obviously verify that using liquid metal based TEG system for waste heat recovery is highly feasible. In addition, the TEG system performance is discussed and a calculated efficiency of 2% in the whole TEG system is obtained. Possible suggestions to further improve this type of generator in the future are given.
► Thermoelectric generator system based on liquid metal to harvest and transport waste heat was proposed. ► Its technical concept was interpreted and basic features were disclosed. ► Experimental prototype was set up which demonstrated the feasibility of the new system. ► Suggestions for further performance improvement are given.
