Biomechanical properties of tenotomy versus biceps knot in a cadaver model

BackgroundBiceps tenotomy and biceps tenodesis are the primary methods of treating biceps pathology. This study describes a new technique of tenotomy with the goal of autotenodesis to give the biceps a higher load to failure and decreased chance of a Popeye deformity.PurposeThe purpose of this study was to evaluate the strength of the “biceps knot”, which is an outlet tenodesis of the biceps tendon and compare the biomechanical properties of this technique to tenotomy.MethodsTen matched cadaver shoulder pairs were used. In the tenotomy group, an arthroscopic tenotomy was performed at the labral biceps junction using a narrow angled biter. For the biceps knot group, a self-retrieving suture passing device was used to pass a suture as far lateral as possible. The suture was passed from just distal to the biceps insertion on the superior labrum and tied with a standard non-sliding arthroscopic knot. The humerus and biceps tendon were rigidly fixed to a materials testing machine and cyclically loaded at 10–20 N for 100 cycles at 1 Hz. After cyclic testing, a 2 N preload was placed on the tendon and the tendon was pulled in line with the bicipital groove until failure.ResultsThe peak load to failure for the biceps knot was 58.9 N (SEM 8.2 N) and 37.3 N (SEM 4.6 N) for the tenotomy group (p = 0.046). The average stiffness for the biceps knot group was 4.2 N/mm (SEM 0.4 N/mm) and 3.2 N/mm (SEM 0.2 N/mm) for the tenotomy group (p = 0.031).ConclusionPerforming the biceps knot is a quick, easy and cost effective alternative to the current tenodesis options available.