Effect of Multiple Coatings of One-step Self-etching Adhesive on Microtensile Bond Strength to Primary Dentin

ObjectiveTo investigate the effect of multiple coatings of the one-step self-etching adhesive on immediate microtensile bond strength to primary dentin.MethodsTwelve caries-free human primary molars were randomly divided into 2 groups with 6 teeth each. In group 1, each tooth was hemisected into two halves. One half was assigned to control subgroup 1, which was bonded with a single-step self-etching adhesive according to the manufacturer's instructions; the other half was assigned to experimental subgroup 1 in which the adhesive was applied three times before light curing. In group 2, the teeth were also hemisected into two halves. One half was assigned to control subgroup 2, which was bonded with the single-step self-etching adhesive according to the manufacturer's instructions; the other half was assigned to experimental subgroup 2 in which three layers of adhesive were applied with light curing each successive layer. Microtensile bond strength was immediately tested after specimen preparation.ResultsWhen the adhesive was applied three times before light curing, the bond strength of the experimental subgroup 1 (n=33, 57.49±11.61 MPa) was higher than that of the control subgroup 1 (n=31, 49.71±11.43 MPa, P<0.05). When using the technique of applying multiple layers of adhesive with light curing each successive layer, no difference of immediate bond strength was observed between the control subgroup 2 and the experimental subgroup 2 (P>0.05).ConclusionMultiple coatings of one-step self-etching adhesive can increase the immediate bond strength to primary dentin when using the technique of light-curing after applying three layers of adhesive.