| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 40120 | Applied Catalysis A: General | 2013 | 10 Pages |
•The Co–Mn–Al LDH precursors were deposited on anodized aluminum foils.•The Mn/Co ratio of 4–8 in solutions was favorable for obtaining active catalysts.•Supported mixed oxide catalysts were tested in the total oxidation of ethanol.•The catalysts specific activity increased with increasing the Mn/Co ratio in solid.•Specific activity of supported catalysts was higher than that of the grained one.
The Co–Mn–Al mixed oxide catalysts over Al2O3/Al supports were obtained by calcination of layered double hydroxide (LDH) precursors formed on anodized aluminum foils during hydrothermal reaction in aqueous solutions containing Co and Mn nitrates. The precursors crystallized as thin curved platelets with nearly perpendicular orientation to the support; the morphology of the deposited LDH films remained preserved after heating at 500 °C, when spinel-like mixed oxides were formed. The Mn/Co molar ratio in the range from about 4 to 8 in the nitrate solution was found to be favorable for obtaining catalysts with demanded contents of active components. The supported Co–Mn–Al mixed oxide catalysts were tested in the total oxidation of ethanol and compared with the grained sample obtained from the coprecipitated LDH precursor. The specific activity of the catalysts increased with increasing Mn/Co molar ratio in the solid up to value of about 0.4. Compared to the grained catalyst, the layers of Co–Mn–Al mixed oxides formed over anodized aluminum foils showed slightly higher specific activity in the total oxidation of ethanol (calculated per a weight of the active components Co and Mn). Formation of main reaction intermediate, acetaldehyde did not change practically with increasing Mn/Co molar ratio.
Graphical abstractFigure optionsDownload full-size imageDownload high-quality image (209 K)Download as PowerPoint slide
