Dynamic Contact Mechanics of Radial Tears of the Lateral Meniscus: Implications for Treatment

PurposeTo characterize the effect of radial tears (RTs) of the lateral meniscus and their subsequent treatment (inside-out repair, partial meniscectomy) on joint contact mechanics during simulated gait.MethodsSix human cadaveric knees were mounted on a simulator programmed to mimic human gait. A sensor was inserted below the lateral meniscus to measure peak joint contact pressure location, magnitude, and contact area. The following conditions were compared: intact meniscus, 30% RT (at the popliteal hiatus), 60% RT, 90% RT, repair, and partial meniscectomy. Data were analyzed in the midstance phase of gait (14% and 45%) when axial force was at its highest (2,100 N).ResultsIntact knees had peak contact pressures of 5.9 ± 0.9 MPa and 6.4 ± 1.1 MPa at 14% and 45% of gait, respectively. RTs of up to and including 60% had no effect on pressure magnitude or location. RTs of 90% resulted in significantly increased peak pressure (8.4 ± 1.1 MPa) in the postero-peripheral aspect of the tibial plateau and reduced contact area versus the intact knee, at 45% of gait. Repair resulted in a significant decrease in peak pressure (7.7 ± 1.0 MPa) relative to 90% RT but had no effect on contact area. Partial lateral meniscectomy resulted in areas and pressures that were not significantly different from 90% tears (8.7 ± 1.5 MPa).ConclusionsSimulated large RTs of the lateral meniscus in the region of the popliteal hiatus show unfavorable dynamic contact mechanics that are not significantly different from those resulting from a partial lateral meniscectomy. Pressure was significantly reduced with inside-out repair but was not affected by partial meniscectomy; contact area was not restored to that of the intact condition for either procedure.Clinical RelevanceLarge RTs in the region of the popliteal hiatus show unfavorable dynamic contact mechanics.