Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
42404 | Applied Catalysis A: General | 2009 | 6 Pages |
Reaction between thiophene and M/γ-Al2O3 (20 wt.%, M = Ni, Co, 2Ni–Co and 2Co–Ni) was studied by thermal gravimetric analysis (TGA) and by sulfidation in a fixed bed microreactor. The samples were prepared by incipient wetness impregnation followed by drying and reduction in hydrogen flow at 450 °C. Formation of bimetallic particles in samples containing both Ni and Co was confirmed by HRTEM with EDX analysis. The reaction with thiophene (20 or 40 mbar) was done at 360 °C in hydrogen atmosphere. TGA of the reaction with thiophene revealed that the initial rate of sulfidation drops sharply when going from Ni/γ-Al2O3 to Co/γ-Al2O3 (by a factor of 40 under used conditions). It follows from the sulfidation in a fixed bed reactor that this difference can be attributed to a poor catalytic activity of metallic Co in thiophene hydrodesulfurization (HDS) and consequently much lower amount of produced H2S in comparison with Ni. Upon sulfidation the HDS activity of Ni-rich particles progressively decreases, while, surprisingly, that of Co-rich particles is enhanced so that after a complete sulfidation (confirmed by XRD and sulfur analysis) the catalytic activity of the obtained sulfides in thiophene HDS increases in the order: 2Ni–Co < Ni < 2Co–Ni < Co.
Graphical abstractIt is found that the rate of reaction of reduced Ni/Al2O3 with thiophene is higher by a factor of 40 than that of Co/Al2O3. The reason of this difference is shown to be a lower rate of thiophene decomposition on metallic Co. In contrast, after sulfidation the activity in thiophene HDS is better for supported Co sulfide.Figure optionsDownload full-size imageDownload as PowerPoint slide